TG - How to add ETH & USDC to your Tangem Hardware Wallet

Before commencing this guide, please ensure that you have your Tangem wallet cards ready to use, that you have the 'Tangem' app installed on your phone, and the all software & firmware updates have been installed so you're running the most recent version.

This guide assumes that you have already set up your Tangem wallet If you have not yet done this, please refer to Tangem's official documentation to activate your device:

TG - How to set up a Tangem wallet

Adding USDC (Arbitrum) To Your Tangem Hardware Wallet

1. Open the Tangem app on your phone

   
   
2. Click on the 3 dots in the top right of your screen

3. Click to open your Tangem wallet

4. Select 'Manage Tokens'

5. Search for 'USDC'

   
   
6. Click on 'USDC'

7. Scroll down and toggle the 'Arbitrum One' network to 'On'

Navigate back to the 'Portfolio' screen

Adding ETH (Arbitrum) To Your Tangem Wallet

1. If you don’t already have ETH on Arbitrum One listed, use the search bar at the bottom of the screen to search for “ETH”:

[NOTE: Bitcoin and Ethereum are both preloaded into the Tangem Portfolio when you set it up, so you might wonder why you have to search “Ethereum” here instead of just tapping on it in the list. The answer is that everything in the portfolio list is network specific, and the pre-populated ETH is specifically on the Ethereum network. So tapping on it will just bring that up. To find ETH on other networks you have to search.]

2. Tap on 'Ethereum' in the search results:

3. Then tap on the “+ Add” button to add ETH on a new network:

4. Toggle on the “ARBITRUM ONE MAIN L2” network.

   
   
5. Click “Continue” button at the bottom of the page

It should now appear in your portfolio on the home screen: